Thermscan-IS Face Recognition Terminal

Features

– Supports Vanadium Oxide uncooled sensor to measure target’s temperature
– Temperature measuring range: 30 °C to 45 °C (86 °F to 113 °F), accuracy: ± 0.5 °C
– Recognition distance: 0.5 to 1.5 m
– Fast temperature measurement mode: Detects face and takes temperature without identity authentication
– Multiple authentication modes are available: card and temperature, face and temperature, card and face and temperature, etc
– Face mask wearing alert: If the recognizing face does not wear a mask, the device will prompt a voice reminder. At the same time, the authentication or attendance is valid
– Forced mask wearing alert: If the recognizing face does not wear a mask, the device will prompt a voice reminder. At the same time, the authentication or attendance will be failed
– Displays temperature measurement results on the authentication page
– Triggers voice prompt when detecting abnormal temperature
– Configurable door status (open/close) when detecting abnormal temperature
– Transmits online and offline temperature information to the client software via TCP/IP communication and saves the data on the client software
– Face recognition duration ＜ 0.2 s/User; face recognition accuracy rate ≥ 99%
– 6000 face capacity, 6000 card capacity, and 100,000 event capacity
– Suggested height for face recognition: between 1.4 m and 1.9 m
– Supports 6 attendance status, including check in, check out, break in, break out, overtime in, overtime out
– Watchdog design and tamper function
– Audio prompt for authentication result
– NTP, manually time synchronization, and auto synchronization
– Connects to external access controller or Wiegand card reader via Wiegand protocol
– Connects to secure door control unit via RS-485 protocol to avoid the door opening when the terminal is destroyed
– Imports and export data to the device from the client software
– * Biometric recognition products are not 100% applicable to anti-spoofing environments. If you require a higher security level, use multiple authentication modes.
– * In order to get an accurate temperature, after the device is powered on, you should wait for 90 min to warm the device up.